DSP-1 Programmer(USB Version)(V2.0)

USB programmer/interface for programming of the MKS programmable digital servos usind a dedicated PC program for Windows® 7 and higher. Power supply: 5-8.4V external battery depending on the servo type.

USB interface - MKS programmable digital servo programmer. With the computer monitor as a user interface, you have a comfortable programming and testing tool. During programming the servo is powered by 5-6 V or 6-8.4 V receveir battery (depending on the operational voltage of the servo) connected to the programmer. All parameters are first set in a window on the screen and then loaded into your servo. The programmer could be also hooked to your receiver for easy servo travel calibration. The operating program can be downloaded from the oficial MKS website

System requirements for using the programmer

• Power supply: receiver battery 5-6 V or 6-8.4 V depending on the operational voltage of the servo
• Operating system: Windows® 7 or higher
• USB port: USB 2.0
• Compatible Servos: MKS programmable digital servos

STANDARD FUNCTIONS
Dead Band: The signal value can be allowed to change under the circumstance without affecting the angle of the output / servo arm. MKS Default = 1μs or 1.2μs
Lock: The setting when the servo does not receive the signal - Keep at the last angular position / The motor is released.
Max. Duty: The duty cycle of the motor will be limited within this value.
Pulse Lower: The minimum angular range will be limited within this command value.
Neutral: The setting of the neutral position.
Pulse Upper: The maximum angular range will be limited within this command value.

ADVANCED FUNCTIONS
Left Angle: Max. Left angle adjustment.
Right Angle: Max. Right angle adjustment.
Reversion: Reverse of the PWM command.
Allow Uncont: The Servo move to the “Uncontrolled Position” when the PWM command is loss.
Uncontrolled Pos: The emergency position in the case of PWM command loss, if the “Allow Uncont” is turned on.
Uncontrolled Time: The Servo will move to the “Uncontrolled Pos” after the “Uncontrolled Time” when the PWM command is loss.

The programmer set includes: DSP-1 programmer, manual.